Abstract template LII Workshop

A. Author1, B. Author2*
1Department of Mechanical and Aerospace Engineering
Distinguished University, Somewhere, UK
2Department XXX
University, Somewhere else, Country

This document is prepared in the format of the proceedings of the Fourth International Discussion Meeting and Workshop. The purpose of this document is to help in the generation of the high-quality proceedings volume. We ask you to submit your 1-page abstracts in the described format. The paper should begin with a four-to-six line one-column abstract as illustrated here. The rest of the material should be in two-column format with margin and spacing as illustrated below.

Introduction
The purpose of this paper is to describe the official format of the papers to be included in the Book of Abstracts of the 2010 LII Workshop. 

Font, Layout, and Margins
The single-page paper should be set in Arial, or closest equivalent, font. The title of the paper and the author’s name(s) and address(es) should be centered at the top of each paper. The title should be in 12-point font and bold-faced and in “Title Case”. The author’s name(s) and address(es) should be in 10-point font but should not be bold-faced. There should be one blank line between the title and the author’s name(s). There should be no other material such as a logo or a running title. The corresponding author should be identified by a superscript [*] and a footnote at the bottom of the page, as shown below. The footnote should run across both columns and should be separated from the text by a solid line starting at the left and of length equal to 5 cm. 
A short abstract (100 – 125 words) should follow the address(es). There should be one blank line between the address(es) and the abstract. The abstract should not be bold-faced and should be margin-justified (Times New Roman 10-point font should be used). 
The remaining text should be set in a two-column format with an Ariel 10-point font. There should be a 2.5 cm margin on the top, left, and bottom sides of the pages and a 2 cm margin on the right side of the pages. This will allow the two columns to be 8 cm wide with a 0.5 cm space between them. Headings of sections within the paper should be bold faced and aligned to the left of the column. The text should begin on the next line after the heading. There should be one blank line between the end of one section and the heading of the next section. Paragraphs should begin with 0.5 cm (approximately 3 letters) indention and should be justified on both sides of the column.

Illustrations
The illustrations and their captions should be included within the manuscript at a location closest to the first reference describing them. The labels, symbols and other information on the illustrations should be no smaller than 10 points. Illustrations may be in color or black and white, but all non-illustration text (including captions) must be in black.

Fig. 1: Experimental setup

References
[1]	 A.B. Author, B. Coauthor, Appl. Opt. 80, 123-245 (2010).